Skip to Content

Entries with tag ipv6 over ipv4.

Implementing IPv6 For Your Business

Breaking it down to simplistic terms, the Internet is a network of computers and mobile devices connected to each other through a series of routers and speaking common protocols. The way that these routers connect computers and mobile devices across the Internet is through either  IPv4 or IPv6 addresses . Knowing about this technical jargon may seem tasking and irrelevant for most businesses. Why not hire someone with IT knowledge to deal with it instead, right? But there is a growing need for businesses to familiarize themselves with some basic knowledge about and the differences between the different types of IP addresses. Let’s start with the growing problem facing IPv4 then go into detail to why implementing IPv6 to work alongside your current IPv4 for your business now will save you and serve you in the future. IPv4, or Internet Protocol...
Read More About Implementing IPv6 For Your Business »

An Introduction to IPv4 and IPv6

The Internet Protocol specifies the technical format of packets and the addressing scheme for workstations to communicate over a data network. The Internet Protocol is designed for use in interconnected systems of packet-switched computer communication networks (see RFC:791 ). IP usually works in combination with the Transmission Control Protocol (TCP), which establishes a virtual connection between a source and a destination or with UDP.  As an analogy, UDP can be thought of as sending a postcard via the postal system. It permits a user to address a packet and drop it in the system/network whereby the user does not have direct contact with the receiver of the message packet. TCP/IP, on the other hand, is more like a bidirectional phone call, where a connection is established the connection between the two hosts so that the two hosts can communicate between...
Read More About An Introduction to IPv4 and IPv6 »

Wait! What?!? My Default Gateway is where?

Let’s start with networking fundamentals: any device communicating on the Internet needs three pieces of information – An IP Address, a subnet mask, or Network mask, and a Default Gateway. The IP address is a *mostly*unique identifier for the host device.  The network or subnet mask provides the host with a mathematical means to determine which IP addresses are local on its directly connected network. If the addresses are deemed to not be local, the host can send the traffic to a locally connected device known as its default gateway.  The default gateway is a device that knows where to deliver the off-subnet traffic.  Modern-day networks provide this network configuration information automatically to the end hosts through the network service, DHCP (Dynamic Host Configuration Protocol) .   The network mask is a not well understood piece of the...
Read More About Wait! What?!? My Default Gateway is where? »

8 Things You May Not Have Known About IPv4 Vs. IPv6

8. IPv4 uses 32 bits for its Internet addresses. That means it can support 2^32 IP addresses in total — 4294967296 IPv6 uses a 128-bit address, supporting 2^128 or 340282366920938463463374607431768211456 addresses. 7.  IPv4 and IPv6 essentially run as parallel networks— they can’t directly communicate with each other and exchanging data between these protocols requires special gateways. This is why being dual-stacked is the preferred configuration as it allows for communication to both IPv4 and IPv6. 6. The current version of the Internet Protocol IPv4 was first developed in the 1970s, and the main protocol standard RFC 791 that governs IPv4 functionality was published in 1981. In 1994 the IETF began designing and developing a new set of protocols and standards that is known as IPv6 which is described in RFC 2460. IPv6 was first deployed in 1998. 5. With IPv4...
Read More About 8 Things You May Not Have Known About IPv4 Vs. IPv6 »

If Your Enterprise Has Adopted “BYOD” Then You NEED IPv6 Adoption NOW

Many businesses today have adopted the “BYOD” (Bring Your Own Device) policy which allows employees to work from their personal devices such as their smart phones or laptops and connect to the company network. Since many of these devices have IPv6 capabilities, this means that they can connect to your enterprise’s IPv4-only network and communicate across an IPv6 link-local network even if IPv6 is not configured on the infrastructure. These un-registered, disguised “covert channels,” what are more recently being called “shadow networks,” pose a huge security risk for your network. Most companies with IPv4 networks don’t have IPv6 security measures in place because they don’t realize that they need to distinguish their security settings for IPv4 vs IPv6. Even though these enterprises haven’t yet deployed IPv6 doesn’t mean they should not monitor and control the inevitable...
Read More About If Your Enterprise Has Adopted “BYOD” Then You NEED IPv6 Adoption NOW »
Showing 1 - 5 of 9 results.
Items per Page 5
of 2

Join Many Other Industry Experts

Sign up for our blog and be on the cutting edge of all things related to Cloud Based Routing.


Browse Blog Topics

There are no tags.